Ts3650

[dancraft]

I Just got a great deal on a used TS3650 table saw and would like to add a table board/router table on the saw. I am not sure the best way to install a board to the fence rails. Has anyone done this ? Any ideas ?
Thanks,David

[biscuit]

Use the forum search function for router table or something similar and you will find a lot of information and pictures. This topic has been discussed numerous times in here.

Welcome to the Forum.

Regards

[Wood_Junkie]

Searched: for 'router extension'

Results: http://www.ridgidforum.com/forum/search.php?searchid=286877

[BadgerDave]

I used these wire clips, http://images.cableorganizer.com/cable-clamp-s.jpg, to mount the board to the spacer bar and a couple of c-clamps mounted to the right wing to act as rests and levelers for the board. Works well and if I ever decide to not use the board any longer there will be no marks or holes left on the saw to indicate it was ever there.