PDA

View Full Version : TS3650 Extra Pieces??? -Help

Wizard
08-25-2007, 09:55 PM
I have just finished assembling my new TS3650 and am a little worried because I have some extra pieces. I really want to get this saw working due to all the great reviews I have read on here but am nervous about the extra pieces. Has anyone had three extra Sq. head screws 1/4-20 x 3/4 and three extra 1/4 flanged nuts? I have reread the directions three times and looked through the online directions since people stated they were a little clearer but I cannot find where these should have been used.
Anyone know where these pieces should be used or are these really extra?? I used all the other 1/4 length screws (and every other piece) just not these 3/4 length.

Thanks in advance!
DSurette
08-25-2007, 10:18 PM
They are used for accessories in the miter slot. You don't need them for assembly. You aren't the first one to ask this question on this forum.

And welcome to the forum!
Wizard
08-25-2007, 10:25 PM
Thank you very much. That means that I can plug it in and use it tomorrow!!!
Bob D.
08-25-2007, 11:33 PM
I have just finished assembling my new TS3650 and am a little worried because I have some extra pieces. I really want to get this saw working due to all the great reviews I have read on here but am nervous about the extra pieces. Has anyone had three extra Sq. head screws 1/4-20 x 3/4 and three extra 1/4 flanged nuts? I have reread the directions three times and looked through the online directions since people stated they were a little clearer but I cannot find where these should have been used.
Anyone know where these pieces should be used or are these really extra?? I used all the other 1/4 length screws (and every other piece) just not these 3/4 length.

Thanks in advance!

You should have started here:
http://www.ridgidforum.com/forum/showthread.php?t=7585

Then most all your Qs would have been answered or at least discussed.
Wizard
08-26-2007, 09:17 AM
You should have started here:
http://www.ridgidforum.com/forum/showthread.php?t=7585

Then most all your Qs would have been answered or at least discussed.



Wish I knew about that post before I started to assemble the table saw. Thanks for pointing it out to me. Time for a little reading.
TOD
08-26-2007, 04:07 PM
They are used for accessories in the miter slot. You don't need them for assembly. You aren't the first one to ask this question on this forum.

And welcome to the forum!
I think you ment to say the are used for mounting accessories to the rip fence.