Craftsman Table Saw Dado Insert

[ELowe]

Can anyone say if the Ridgid AC1025 Dado Insert might fit in my old Craftsman table saw. The table saw is a 113-299040 model, and Sears no longer supports it. I even called them, and the guy couldn't even pronounce "dado".

Thanks for any advice.

[philwells]

I think this should work:
http://www.highlandwoodworking.com/index.asp?PageAction=VIEWPROD&ProdID=2649
I am ordering one now so I can't CONFIRM it works but everything is right except it probably doesnt have the little clips underneath to hold it in place.

I have the 113.299040 and I measure the throat plate at 14 3/8 x 3 3/4. Grizzly has one the right size but not rounded:

http://www.grizzly.com/products/h0629

It's also cheaper at Highland and I can vouch for their good customer service.

Phil
San Diego

[BadgerDave]

I can't help you as far as the dado plate is concerned but I will echo Phil's statement about the good customer service at Highland Woodworking.

[threecreeks3]

I've made many a dado plate with plywood and the green slick plastic.Its pretty simple and easy to do ..then too u can make the plates to the width the dado is set at.I prefer the wood or plastic over a generic width metal plate.
Sam