Table saw cove...

[funeralguy82]

I set up a diagonal fence on the 3650 and cautiously ran a cove through a board on both edges... I then cut the board in-two and mitered the ends. (This will make up the roof of the gnome-home I'm making for my mother). Any ideas of how to reinforce the joint at the peak of the roof... should glue alone be okay??? Note: I have no biscuit joiner yet... :(

Here's a pic of the coves...
and the gnome... lol...

http://a657.ac-images.myspacecdn.com/images01/62/l_60faf22b06aed1b1cc4fdeec95f5fb00.jpg (http://viewmorepics.myspace.com/index.cfm?fuseaction=viewImage&friendID=81925238&albumID=1748153&imageID=22578117)
http://a586.ac-images.myspacecdn.com/images01/52/l_a1d453f9ba30fc55d41b179541eb4bd1.jpg (http://viewmorepics.myspace.com/index.cfm?fuseaction=viewImage&friendID=81925238&albumID=1735002&imageID=22578958)

[KenM]

I set up a diagonal fence on the 3650 and cautiously ran a cove through a board on both edges... I then cut the board in-two and mitered the ends. (This will make up the roof of the gnome-home I'm making for my mother). Any ideas of how to reinforce the joint at the peak of the roof... should glue alone be okay??? Note: I have no biscuit joiner yet... :(

Here's a pic of the coves...
and the gnome... lol...




Use splines on the inside of the corners:
2814

[funeralguy82]

I'll have to try a spline... and cut molding to hide it...