Pez
03-30-2008, 05:32 PM
I am having some difficulty getting the fence aligned. The first issue is when I tighten the bolts on the fence it tends to move a little. I can more or less get past this issue but the bigger problem is once I think I have it all done. I will take the rip fence off and put it back on and when I recheck the measurements its off by approx .004 inches from front to back. It seems no matter how close I get it once I take the rip fence off and put it back on its no longer as square as before.
What is an acceptable tolerance? I would have to think that I have gotten the fence square to the blade much closer by using the dial indicator compared to method in the manual. I spent a lot time on this and want to move on but want to make sure the alignment is good enough.
What is an acceptable tolerance? I would have to think that I have gotten the fence square to the blade much closer by using the dial indicator compared to method in the manual. I spent a lot time on this and want to move on but want to make sure the alignment is good enough.