brantnative
04-19-2008, 06:19 PM
I have two questions:
When I tried to change the planer blades I found the wrench supplied with the planer is too thick. Is this normal? Do I have to go out and buy my own wrench?
While using the planer, vibration must have loosened the screw holding the Indi-i-Cut assembly together. I've tried several ways of putting it back together but I can't quite get it aligned. Is there a trick?
When I tried to change the planer blades I found the wrench supplied with the planer is too thick. Is this normal? Do I have to go out and buy my own wrench?
While using the planer, vibration must have loosened the screw holding the Indi-i-Cut assembly together. I've tried several ways of putting it back together but I can't quite get it aligned. Is there a trick?