harperrc
04-24-2008, 09:56 AM
i just got my 3650 on sale and am in the process of putting it together.
after i attached the first wing and tightened it down i put my level across
the table and noticed a slight droop (maybe a 1/16).
a) is this normal ?
b) is it ok to just put some shims at the joint to level the table or should i take it back ?
very good information in the forum
after i attached the first wing and tightened it down i put my level across
the table and noticed a slight droop (maybe a 1/16).
a) is this normal ?
b) is it ok to just put some shims at the joint to level the table or should i take it back ?
very good information in the forum