3650 to DC

[Richard$]

Seeking advise to conect my new Delta 50-760 Dust Collector to my TS3650. My old shop vac easily attached to the TS outlet. While trying to get my DC to connect to the TS I was dumb-founded twice. First the 4"x 2 1/2" I bought is the wrong size (id vs od). Secondly the TS's dust connection is angled downward and toward the left rear leg. Holding the 4"x 2 1/2" to the TS's dust connection, it appears to me the 4" hose would be difficult at best, to mate the two machines together. So my questions are, is the 4"x 2 1/2" available, or do I simply use a 2 1/2" coupler. Next should the 4" hose simply reduce down and attach or do I install a ellbow to compensate for the TS's angled dust connection and left rear leg.

[KenM]

I found it easier to use a short piece of 2 1/2" hose from the 3650 to the floor, and connect that to a 4" hose.

[FINER9998]

check out the threads on dust collection and the 3650. adapting whats stock so that it will accomodate your 4" dust collector will greatly enhance its effectiveness.

[gwshaw]

The outlet on the TS3650 is angled so that at a 45 degree bevel it is about the same angle on the other side.

I have exactly the same setup and use a 4" to 2.5" adapter that has the 2.5" at one edge rather than centered. The 2.5" fitting fits into the saw directly. It is a small amount of trouble to get on, but works great.