PDA

View Full Version : Stem I.D.

JCsPlumbing
07-28-2008, 02:28 PM
Can the forum ID this diverter stem? Three handle T/S faucet.

Thanks.

J.C.
wrench spinner
07-28-2008, 02:38 PM
It looks like a Gerber diverter
wrench spinner
07-28-2008, 02:43 PM
yep gerber GB5003

http://www.alfanoplumbingparts.com/
boillerman
07-28-2008, 06:28 PM
Looks like Gerber to me too. Pull the seat, should be a 4 sided seat wrench. Sometimes it's easier to ID the seat than the stem.
ridgidpipe
07-28-2008, 08:19 PM
I would say Gerber also but it looks like the put a repair handle kit on the spline .
Those handle kits are terrible always strip out
Home depot doesnt carry those stems around me I get them at the local hardware store as there are a lot of gerber faucets in a condo developement near me