Left over bolts on ts3660

[BOOMER1725]

Hi
I need help I just finished assembly on my new ts3660 table saw Now I have three bolts and nuts left over they are 1/4-20 X 3/4 square heads they are in blister package. unable to see any reference to them in instruction manuel Thank you

[harrison2119]

I believe they are to fit in the slot on the fence to attach jigs or a sacrafice fence for dadoing.

[Bob D.]

Read this thread.
http://www.ridgidforum.com/forum/showthread.php?t=7585

FAQ #1 is:

Q1. What are those three extra bolts and nuts for? Did I miss something during assembly?
Answer: No, the three bolts and nuts are supplied for mounting an axillary fence on the table saw fence. Keep them in a safe place until needed. You may also have a few extra brass shim washers when you are done, save them too.

Read through the entire thread for a load of help on assembling and maintaining your TS-3650 or 3660.