Saw Dust Maker
05-12-2009, 10:50 AM
Hello Everyone,
I am new to the forum but not to woodworking. I had sold my old craftman table saw and bought the 4511. I just got it this past weekend. Have not had a chance to really use it yet. I have been doing some adjustments and fine tuning. I have a TS-Alignment Jr. kit that I have been using. I must say, I am impressed of the readings right out of the box. However, I did have to adjust the miter slot with the blade. I, too, have noticed though that when I get the table aligned with in 0.001 and begin to tighten the screw that is located on under the table on the left side toward the back, the needle moves out of range. I believe I will use one of the suggestions on the forum of using nail polish to "set" the hex screw where it is now to keep the table aligned. Any other suggestions on this? Also, just wondering about the fence. Has everyone using this saw so far fine the rip fence to be good?
I am new to the forum but not to woodworking. I had sold my old craftman table saw and bought the 4511. I just got it this past weekend. Have not had a chance to really use it yet. I have been doing some adjustments and fine tuning. I have a TS-Alignment Jr. kit that I have been using. I must say, I am impressed of the readings right out of the box. However, I did have to adjust the miter slot with the blade. I, too, have noticed though that when I get the table aligned with in 0.001 and begin to tighten the screw that is located on under the table on the left side toward the back, the needle moves out of range. I believe I will use one of the suggestions on the forum of using nail polish to "set" the hex screw where it is now to keep the table aligned. Any other suggestions on this? Also, just wondering about the fence. Has everyone using this saw so far fine the rip fence to be good?