OUTFEED TABLES

[toolguy1000]

DOES ANYONE HAVE ANY PLANS OR IDEAS FOR ADDING AN OUTFEED TABLE TO A TS2412 EQUIPED WITH AN AC1036(THE 3'RIP FENCE)? I'M NOT A BIG FAN OF DRILLING HOLES IN PERFECTLY GOOD EQUIPMENT SO I AM PRIMARILY INTERESTED IN SOMETHING THAT COULD BE HUNG FROM EXISTING HOLES OR BOLTS. I'D ALSO LIKE TO MAKE IT REMOVABLES SO IT CAN BE LAID FLAT ON THE TABLE SAW TOP TO PROTECT IT AND DOUBLE AS A VERY LIGHT DUTY ASSEMBLY TABLE.

[BadgerDave]

Sorry I don't have any specific ideas as to your particular needs for an outfeed table. However, you might get more responses if you put this question to the members down in the woodworking forum.

[toolguy1000]

i'm very new to this. could you point me to a source for information as to how i do that. thanks

[BadgerDave]

You posted this thread under the "General Plumbing Discussion" forum which is located at the top of the BB's Home Page. Further down the Home Page, you'll find a forum titled "Tips and Technuques". Post your question there.

[plumber]

Yes a different forum would help. On this forum, if you would like, like we can get water to run from your dust chute when the switch is activated.

Just kidding, welcome to the site and hope you have luck with your question in the other forums.

[papadan]

OOOOO Plumber, that sounds kinda cool. LOL