Completed 1st project..

[Reboot]

I completed my first project with me Rigid TS3650 Table Saw. I think the saw is A1.

My first project was a router table\cabinet. The router plate is about 1/16" or 1\32" low compared to the table. Is there a way to fix this.

TKS. Reboot :confused:

[Rafael]

First, how about some pics?
Only 1/16"? Maybe some thick tape should level it.
I've used tables where the plate was not flush, they worked fine. But you might as well make it perfect.

[Reboot]

Ok tks, will try that. :rolleyes:

[BadgerDave]

Maybe you could install set screws in the four corners similiar to the setup on your saws throat plate.

[msoomro]

My first router table's plate was about 1/32 too low. I just put slivers of wood from my handplanes to get it just right. But masking tape or aluminum foil should work just the same.

[I-9]

I had to shim the T track on my table and used masking tape........the blue tape is easier to remove if you ever need to. Did you make your own plate? The reason I ask is that all the commercial tables have levelling screws.

[Reboot]

Yes I made it out of 1/4 inch plexie glass. ;)