Laser line light for my MS1250

[larrylsb]

Does anyone know where I can find an after market laser light that WILL work on the Ridgid MS1250 saw? All the ones I have seen say they do not work on the 12" Ridgid saws.

[papadan]

The 12" saws have a larger arbor size than the 10" saws. Check with Ridgid parts. They make a 12" that has the laser.

[BadgerDave]

Try here. (http://www.laserkerf.com) You did say you wanted one that works, right.

[ 03-18-2005, 08:58 PM: Message edited by: badgerdave ]

[imported_wbrooks]

That is about the only one on the market that does work.

[Goodrich_Mike]

larrylsb

I believe it was badgerdave who recommended the Laserkerf to me when I posed the same question.
I purchased one of the devices and installed it on my 1250. When I purchased it I was contracting so it got moved from job to job. Because of how it is mounted you need to do a fast and simple alignment before using. I have since gone to work for the big orange box in the millwork dept so it stays in my shop and does not move (except to clean around). I have not had to adjust it much if any since it is stationary. I recommend the purchase you will be happy with the device. It is more adaptable than the other solutions in my opinion.