DCH
02-20-2001, 10:42 PM
I purchased the oscillating edge belt sander last fall and other then some minor messing around I never really tried it out until recently. After edge sanding a couple of boards using the belt sander I noticed that the sander was not square to the table. I double checked all of the setup, and then changed over to the spindle to see if it had a similar problem or not. The problem exists on the spindle sander as well.
So I guess my question is has anyone else noticed this and if so how did you solve it?
I have looked at everything I can to see if I can square the motor/spindle to the table and unless I'm missing something I don't see how it can be done. Thanks in advance for any input, and before anyone ask's why I just don't take it back, I guess I just feel a little guilty not noticing it before now.
So I guess my question is has anyone else noticed this and if so how did you solve it?
I have looked at everything I can to see if I can square the motor/spindle to the table and unless I'm missing something I don't see how it can be done. Thanks in advance for any input, and before anyone ask's why I just don't take it back, I guess I just feel a little guilty not noticing it before now.