Tablesaw Rip Fence

[appsys]

I've had the TS2412 Table Saw for 2yr.
No real precision work, til now.
The Rip Fence is not parallel to the miter
slot of the table. It's about 1/32 closer
to the slot on rear than the front.
Is there any way to adjust it, or is the
Rip Fence defective and I never knew it.

[Dave Arbuckle]

I just looked in the on-line manual for the TS2412 model 0. Yours might be a bit different, but in this one, fence alignment starts on the top of page 22. It's a rather simple process, and the manual even includes a couple drawings to show exactly what needs to be done.

This might be a good time to run the whole tuning process on the saw. Most complaints I have heard on contractor's saws are solved with a good tuneup. Kinda like pulling half the sparkplugs out of your car, just doesn't run so good. ;)

Dave