gr8tgreg
01-10-2001, 11:51 AM
My 4-month-old TS2412 table saw has a problem with the fence. The rear portion is too high off the table top. If I'm cutting 1/4" ply, the ply will slip under the fence and jam. I've adjusted the rear rail as low as it will go, and still have the problem. If I can lower it by 1/32" or 1/16" I should be o.k.
It's pretty scary and unsafe when the 1/4-ply jams on me, not to mention the crooked cuts.
Any ideas on how to lower the fence? I didn't find anything in the owners manual.
It's pretty scary and unsafe when the 1/4-ply jams on me, not to mention the crooked cuts.
Any ideas on how to lower the fence? I didn't find anything in the owners manual.