new saw types

[brian]

just wondering if there is any planed in the making for one of them panel saws that home depot uses to cut plywood, paneling ect...
if not can u make one or does anyone know where i can get some hardware to make one..

thanks brian
let me know

[JSchnarre]

Brian,

There are no plans at this time to manufacture a panel saw. I have seen several plans to make one using a circular saw. Matter of fact I believe Shop Notes Magazine had a set of plans some time ago.

Jake

P.S. I went back and did some searching. The plans for a panel saw were in Shop Notes Magazine No. 4 Vol. 1. Hope this helps.

[Billiam]

Brian
If i'm not mistaken Rockler has one avaible or has the plans for one Http://www.rockler.com try this address. I'll also check and see if I can find the one that I saw before. Go luck

[ 07-07-2001: Message edited by: Billiam ]