67.5 MITRE cut??

[HomeHandyGuy]

I have installed a new kitchen and need to cut a 67.5 in angle (135 degree corner) to complete the light molding. My saw only goes to 50 degrees so there must be another way. Any advice would be welcome as I have gone through a stack of scrap trying to figure it out.
Thanks,
Harvey

[wbrooks]

set the saw at 22.5
90 - 22.5 = 67.5

[HomeHandyGuy]

Thanks Wayne...feel stupid now because it is so simple. I did cut some pieces at 22.5 but never checked the discarded "other" half. I was so used to working with the 22.5 on many of the corner cabinets I just had a mind blank. I will be back on the job tomorrow and will finish up this last piece of moulding.
Harvey