PDA

View Full Version : Need help, please - Tablesaw Assembly question

samill2
02-11-2006, 12:01 PM
Hello. New guy.

Wasn't sure where to post this but I figured the woodworkers would know as much about a tablesaw as anyone:

I'm assembling the TS3650 10". I'm at the point of installing the Rip Fence Guide Bars. Now, the instructions say use a straightedge to align the "Mark on Rear Guide Bar" with the blade. Simple, right - but there is NO mark on the rear guide bar. Does anyone know any other way I can make this alignment? Is there some point I can measure from to make this alignment?

Thank you.
TOD
02-11-2006, 12:12 PM
The sticker must have fallen off. The mark is 14 3/16" from the left end of the rail as viewed from the front of the saw. Hope this helps.
samill2
02-14-2006, 07:22 PM
The sticker must have fallen off. The mark is 14 3/16" from the left end of the rail as viewed from the front of the saw. Hope this helps.

That's exactly what I needed to know. Thank you.