0610 Jointer on a Hercu-Lift?

[ironhat]

Has anyone made this adaptation? I haven't been to HD to check on the minimum machine base size to fit but couldn't the jointer be mounted on ply and then that adapted to the H-L? Hmmm, I'll bet the dimensions are online... Any experiences appreciated.
Later,
Chiz

[MrZ]

Has anyone made this adaptation? I haven't been to HD to check on the minimum machine base size to fit but couldn't the jointer be mounted on ply and then that adapted to the H-L? Hmmm, I'll bet the dimensions are online... Any experiences appreciated.
Later,
Chiz

I picked up the H-L for my jointer, but could not get it to fit. The base of the jointer is too narrow & too long for the lift to work properly.

[ironhat]

I picked up the H-L for my jointer, but could not get it to fit. The base of the jointer is too narrow & too long for the lift to work properly.

Thanks, MrZ. I though as much. I currentlyhave it mouted on a piec of ply mounted to one of those 3-wheeled mobile bases. The kind where the big caster in the front has a pedal to raise and lower it. It doesn't function too well - always having to drag the unwilling caster.
Later,
Chiz