TS 3650 level problem

[franklin pug]

I have set up my new TS 3650 on a not so level garage floor. I have placed the rear feet on a 1x4 and raised the rear feet over 1/2 of there distance to level the table of the saw. I gave the table a push and a pull and it seems pretty stable - should i be concerned?

[BadgerDave]

I wouldn't be too concerned. As long as the saw is stable and you're not banging it around you should be fine. I would keep the table top well waxed and just to be on the safe side you could change out that 1x4 with a 1x6 or even a 1x8.