Dado Insert For The TS3650

[kevin smith]

Has anyone out there made a dado blade insert for theTS3650 table saw. I have looked for one to buy but no luck.

If you have any ideas, please me know.

thanks

Kevin Smith

[BadgerDave]

Use the Search feature and the top of the page. Type dado insert as your search subject.

[TOD]

I have made several. The procedure is the same as making a ZCI. I mark the dado size on the back after making them so if I need that size again all I have to do is take it off the hook and install it.

[Wood_Junkie]

I bought a few of these. The official Ridgid model, or the one from Woodcraft, runs about $70. These are $15 each.

http://www.ptreeusa.com/zero_clearance.htm

Make sure you order #949, for the Ridgid 3650.