I was wondering if there is instruction manual , parts break down, and a schematic drawing for the tool box monitor available?
There are these blue wires that lead up to the CRT just under the pivot point its heat shrink and I notice it turns the unit on and off indeterminately. Is it a micro switch for when the CRT is folded down it turns off the unit? or is it some sort of fusible link?
The CRT cracked a few years back, and I never replaced it now that you all came out with the RCA interconnect cable for the MicroExplorer, I want to revive this guy since it will power the SeeSnake nicely and has a Video out. I will just use the MicroExplorer as my monitor.
I've not ever seen that monitor. kind of looks like a sweet little setup. Mine are the viedo toolcases, similar but bigger with a vcr in them.
I've never seen anything to plug into the aux connector. mine have din plug outs for vid and sound which I use. In the toolcase monitor manual there is a pinout for the aux connector on pg 15, which may apply to your box as well.
Thread of the Week Award(s): 3
Tool Box Monitor
Linear Mode
