On this part, I made a new wider (or longer) "Hold-Down plate" for holding long pieces better while ripping.
As you'll see, I used screws to connect the support to the sled but later, I used two dowels instead of the screws for faster "ON-OFF" of the hold-down.
Another aid is the "hold-down block" for cross-cutting
It's still not the final and a few changes are going to take place...
Well, I'm still far from the end of my curing (at least, another 3 months)...
Those pics are from the last summer but when I went through my posts, I noticed that I didn't post it here yet so, I'm doing it now to complete the "list" (it's the only forum on the internet that you can find all my posts/jigs).
As for "Intricate", well, maybe a little bit but, as you will see on the next (part 6) and the "final version", I removed/replaced a few things to simplify the operation.
TS Sled - Part V
Linear Mode
