No announcement yet.

Actual tool idea submission procedure

  • Filter
  • Time
  • Show
Clear All
new posts

  • Actual tool idea submission procedure

    I'm an inventor and have a tool that I actually think could be an asset to Rigid. The tool has been field tested and has great synergy with the existing product lines offered.

    Other that this informal forum, does anyone know the formal procedure for submitting ideas to the Rigid R&D department?

  • #2
    Re: Actual tool idea submission procedure

    Talmzor, the official route is to submit through this.

    choose "marketing - new tool ideas" as the recipient.


    • #3
      Re: Actual tool idea submission procedure

      Josh should be able to get you a contact name and number.

      If you haven't already check out this and other sites along with the USPTO website.

      Josh, if you do dig up a contact within RIDGID, maybe you could post a sticky to this Forum with that and any other information which might be available (maybe a contact email like inventions @ which could be forwarded to whoever's personal email address.

      You are fast Josh, as I was writing this you answered the Q.
      "It's a table saw, do you know where your fingers are?" Bob D. 2006


      Time, cost, or quality; pick any two but you can't have all three.