If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Sounds like a great idea. I personally don't have much use for a beveling machine, but I do some work on piping to be welded. I use an small angle grinder to bevel the edges on the pipe. The largest pipe I use is 2", and it's for fabricating frames, but I'd imagine it's got to be time consuming for somebody who's got to do larger piping. Plus a two-in-one tool could save money, since you wouldn't have to use more than one set up, and it would make time and production more efficient.
Marcus Rinaldi<BR>Service Tech<BR>F&W Heating & Cooling