If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Well, with all the sarcasm floating around these days, its hard to know who is pulling whose leg (or should that be 'whom's leg' ), but assuming you are not familiar with them Dale in WV, the WWII stands for Forrest WW10407100 Woodworker II blades, not World War II blades.
It is impossible to make anything foolproof because fools are so ingenious.
Ken and all,
Forrest makes good blades. A carpenter friend of mine said they are better than Freud which I've read much about here.
My fairly new TS3650 only has the Ridgid factory blade still installed. Do I want this Forrest blade as a replacement to that?
The Forrest is pretty amazing. Freud makes one blade that should compete with the Forrest 40T WWII...the F410 has a similar design and is close in price. There's a DeWalt DW7657 that's similar but isn't sharpened to the same degree, but is a bargain at around $50-$60. Then there's a Ridge Carbide TS2000 that's considered as good or better than the WWII by many...it's sharpened to 1200 grit and the carbide is thicker to withstand more sharpenings. Any one of these blades should perform extremely well on a wide variety of cuts and materials in your saw.