Announcement

Collapse
No announcement yet.

chamfer short pieces of CPVC pipe

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • chamfer short pieces of CPVC pipe

    Hello,

    I am wondering how I can chamfer the outside of short pieces of CPVC pipe - these are only 1.5 inches long and 1 inch diameter. I have several hundred to do at a time, about one batch per month.

    I used these pieces to connect Tees, elbows, connectors, etc. The pieces are cut with a tube cutter but the outside edge is sharp and will push up some CPVC during solvent cememting.

    I can bevell the inside using an 82 degrees countersink in a drill press - very fast and clean finish.

    I just have no good ideas to do the outside.

    Any thoughts from anyone?

    Thanks, Ron
Working...
X