If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Re: AS clint said " Whats' the diff "????????
Think of a drill, same drill bit put on slow speed then put drill on fast speed. The slower speed, the drill bit torques and goes in slow but grabs more. At high speed, you apply less pressure but the bit cuts faster. Sectionals go from 450-710 rpms(k60 is 600) while drums are around 200rpms.