If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I ran across a bootleg gas stove install today and the handyman used csst.Code now requires this is to be bonded.So...
how is this properly done?
Good luck. This issue had been brought to the NEC Board in Boston. What they would like to see done is the manufacturer install a grounding lug on each fitting, so a bonding jumper can be installed from the pipe to the stove fitting.