If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Yes, but normally you would bring a 2 wire 240v feed circuit to the T stat and then a 2 wire feed to the heater. However, you want to bring the feed to the heater first. So to do that you "should" then bring a 2 wire switch leg to the T stat and then a 2 wire switch leg feed back to the heater. Not a good idea to break only one leg. I would opt to bring the circuit first to the T stat and then to the heater if possible.