If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Re: "Outstanding jaws" for cutting big pipe w/Ridgid 300/535
There use to be another supply house that sold something similar, it was a shaft that went into the head of the 300 machine and had three bars that were perpendicular to the shaft on the very end, there was a clamp on each bar that would clamp onto the end of the pipe. I welded one up myself and used it on a bunch of eight inch pipe, very dangerous in my opinion, turned way too fast. It still sits over in the shed somewhere collecting dust and rust.