No announcement yet.

Quality control

  • Filter
  • Time
  • Show
Clear All
new posts

  • Quality control

    The crimping system returns always high level same quality joints and this within a crimping time of seconds. It is impossible for any craftsman to reach this quality in the same time. The competitive advantage increases with the size of the fittings to crimp. What surprises me at this time is that there is no crimping over a diameter of 2". Is there any development in view? May we get crimping tools for those diameters? If yes, when do you market such products and what sizes could we expect?
    Thank you for your kind reply.


  • #2
    Terry, Good news! The 2-1/2" through 4" jaws are now available. The catalog number for the whole set including the required ring actuator is 93667.

    [ 12-17-2002, 02:17 PM: Message edited by: Ronnie ]


    • #3
      Thank you for your reply. I have seen the crimp rings sizes 2 1/2", 3" and 4" on your web add and I have to tell you that I already tried them out. Congratulations: its really the tool for the future and if somebody likes christmas gifts, its the best investment one could eve do for the coming up year 2003!!!