Announcement

Collapse
No announcement yet.

horizontal band saw making poor cuts

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • horizontal band saw making poor cuts

    I have a horizontal band saw that is not cutting straight. I have replaced the guide bearings, blade, and squared up the vise to the blade.
    I used a carpenters square to check the blade travel. When starting the blade flush against the top of the square. In a 6 inch cut the blade
    is an 1/8 inch away from the square at the bottom. Any suggestions on a cause or a solution would be greatly appreciated.

  • #2
    Duplicate topic, closing to the thread in Open Discussion.

    https://www.ridgidforum.com/forum/ge...king-poor-cuts
    "It's a table saw, do you know where your fingers are?" Bob D. 2006

    https://www.youtube.com/user/PowerToolInstitute

    https://www.youtube.com/channel/UC1p...qcZKHyrqKhikFA

    ----

    Comment

    Working...
    X