If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
MAINTENANCE NOTICE: The site will be down for maintenance on Sunday, 14 Feb 2015, between 9:30AM and 11:30AM Eastern. We apologize for any inconvenience!
I bought these when they first came out. At first they had a very low flow rate but I was to lazy to change them and now they work very well as far as how much water is used. Would I use them again, no. Reason is that most broken hoses don't break wide open, usually it's a little drip and this product won't guard againt that.
I did see a product on TOH that I found interesting but never looked further into it. It was a solenoid valve on the hot and cold side. You plugged the valve into the outlet and the washer plug into the valve. Even had it's own expansion tanks for both sides. This might something I might do in the future.