If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
We do not have a specific pipe die for copper, however, we have recommended that the customer to try our dies for PVC. Our regular dies for pipe are made to be aggresive which on brass can tear the threads. The dies for PVC are not aggresive which will work much better. Also, when threading Brass pay attention to the feed rate, if the threading process seems to be going to slow, you may have to maintain pressure on the hand wheel.