Announcement Announcement Module
Collapse
No announcement yet.
Jointer outfeed table Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Jointer outfeed table

    Can anyone help me adjust my outfeed table? I loosened the wing nut, but the bed does not move. Must be something I'm missing.

    Mike

  • #2
    Re: Jointer outfeed table

    Refer to page 30 of the online manual, - adjusting table gibs.
    The outfeed table may be frozen to to dovetail ways with old greese or rust.
    If you loosen the gibs (either side of the 'wingnut' that you loosened) it may free up. You may need to wiggle a bit or even tap with wood block and light hammer taps

    Comment

    Working...
    X