Announcement

Collapse
No announcement yet.

Incra mitre gauge on a TS3650?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Incra mitre gauge on a TS3650?

    A week ago I bought a TS3650 at HD and I love it. This is not my first table saw, and it has all the features I was looking for. Comparing it to the low end hybrid I was looking at, I'm not the least bit disappointed.

    My question is about the mitre gauge. The gauge on the 3650 is good, but not fantastic, and I am thinking about something like the Incra 1000se (which I have used before and liked).

    Has anyone used this mitre gauge on a TS3650? If so are there any gotcha's?

  • #2
    Re: Incra mitre gauge on a TS3650?

    Absolutely no gotcha's. I've been running the 1000SE on my saw for a few years now and the only regret I have is that I didn't do it sooner.
    Last edited by BadgerDave; 03-09-2008, 04:46 PM.
    ================================================== ====
    All of us could take a lesson from the weather. It pays no attention to criticism.

    Comment

    Working...
    X