If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Depends on how old they are and what shape they're in. If both are in very good condition then I'd say that the planer is priced in the right range but the jointer is well on the high side for a used machine.
Also, keep in mind that you may have a problem down the road finding replacement knives for the planer. The jury is still out on whether or not Ridgid will still be producing the TP1300LS after current HD inventories are depleted.
I decided to change calling the bathroom the "John" and renamed it the "Jim". I feel so much better saying I went to the Jim this morning.
Seems like a good price. Yes, planer knives are a sought after item - keep your eye out for them, be it on eBay or wherever, and pick them up when you can, so you're not left running in circles trying to find them when you need them.
They are not resharpenable, if you want to use the easy drop-in indexing alignment.. If you want to endure the pain of aligning them, perhaps they could be sharpened...
Remember, your planer blades are reversible, AND the planer itself came with one spare set (two sided). So think about picking up one or two extra sets... but a stockpile of blades might outlast the machine itself!
I picked up one spare set, in addition to the spare set that comes with the planer. But frankly, I'm still on my first side of the stock blades. That gives me five (5) changes on-hand if needed.
My current blades have two tiny nicks in them that leave a very small ridge on the boards I plane. It takes about 5 minutes with a plane or scraper to remove them, so I haven't changed 'em. The planing cut quality is still quite excellent over the rest of the surface. I've put about 750 BF of mixed species through my planer in the last 2 years... cedar, black walnut, red oak, maple, pine, cherry. I keep the rollers cleaned and I only take a MAX of 1/16 per pass..