If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have no experience with the CMT dado set however their stuff generally receives high marks for quality. I doubt if you'll be disappointed but again, I have no personal experience with this set. How's that for a non answer?
I decided to change calling the bathroom the "John" and renamed it the "Jim". I feel so much better saying I went to the Jim this morning.
I've had the Freud SD208, DW7670, Systimatic 42T/6T, and the Infinity Dadonator. The best I've used in that price range is the DeWalt 7670...also available as a Delta, with the Dadonator being the best overall. The CMT has 12T cutters and 2T chippers, much like the Freud SD206/208. The better sets have at least 24T cutters and 4T chippers.
I've tried a few CMT blades and still have one...they're good blades but haven't really been overly impressed relative to what's available from Infinity, Forrest, Ridge Carbide, the better Freuds, Tenryu, the better DWs, or Amana in similar price ranges. Oshlun is one of the better value names I've tried. Holbren has a couple of Oshlun dados < $80, that use the same design that my 42T/6T Systimatic uses, and that was a mighty fine set. I think you can do better than the CMT in that price range.