If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
MAINTENANCE NOTICE: The site will be down for maintenance on Sunday, 29 November 2015, between 12PM (noon) and 4PM Eastern. We apologize for any inconvenience!
Not enough space for an 8" jointer in my one car garage so I am looking at an opportunity to buy a used 6" Ridgid, Model JP06101. The machine is 2 years old, advertised as "hardly used" and the price is $350 CDN (approx. $290 US).
In order to understand recursion, one must first understand recursion.
That certainly isn't a red hot smoking deal by any means. If the jointer is in pristine condition then you'd be saving around $100(US) over buying new. You would however not have the coverage of the LLSA Program on the jointer if that is worth anything to you. If the seller is also going to throw in a set or two of new knives that would sweeten the pot a little.
All of us could take a lesson from the weather. It pays no attention to criticism.