No announcement yet.

4511 miter problem

  • Filter
  • Time
  • Show
Clear All
new posts

  • 4511 miter problem

    Hi all I'm new here. I just got a 4511 TS and once set up went to put the miter gauge in the slot and it will not fit!! Will not go in from or back or on top in any slot it you try to make it the table start to crack. Took the miter to HD and it slide right is the metal top saws but the did not have another 451.

    Could not get though to Ridgid today busy all day. Still waiting for email from Sunday

    Any thoughts is there a to putting them in this is so tight that it is scraping steel off both side and the bottom

    Thanks Hess