Announcement

Announcement Module
Collapse
No announcement yet.

tp1300 issue

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • tp1300 issue

    I have a TP1300 adn when I run wood through and take more than 1/32 off the motor bogs down and stops completely... anyone else ever had this issue? I checked the brushes and they are fine any ideas???

  • #2
    Re: tp1300 issue

    Dull knives, dirty rollers or both would be my guess. Also, rewaxing the table every so often is a good idea.
    Teach your kids about taxes..........eat 30 percent of their ice cream.

    Comment


    • #3
      Re: tp1300 issue

      I would say your motor is shot. Even with really dull knives you should not be able to stall the motor unless you are plaining 1/8" off 13" wide Lignum vitae. Stalling the movement of wood through the planer is another story

      Comment

      Working...
      X