Announcement Announcement Module
Collapse
No announcement yet.
Ridgid 10501 10" miter saw bearing question Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Ridgid 10501 10" miter saw bearing question

    I just took out my old 1050-1 miter saw to do some 5.5" baseboard molding. I must use the bevel cut due to the height of the molding. When i start a 45 deg bevel cut, the saw starts cutting fine (going slow thru wood) then starts to vibrate a bit sometimes halfway through the cut and leaves a circular mark in the end of the cut wood throwing off my nice 45 bevel. Is this possibly a bearing issue? (i just replaced the blade)

    Thanks,

    Damian
Working...
X