Announcement

Collapse
No announcement yet.

Problem heeling R4512

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Problem heeling R4512

    I would appreciate any advice on how to get my R4512 to stay heeled. I just purchased the table saw (my first Rigid tool) last weekend. Out of the box it was just a little off, so I followed the instructions in the manual. It took me probably 30 minutes to an hour to get it heeled. After making 3 or 4 cuts, I checked it and it was back out. I have tried it 2 more times and each time the same result. Is there something I am missing?

  • #2
    Re: Problem heeling R4512

    So, I just went out and made several cuts on a piece of wood - ripping and cross cutting - and put the square to it. It was square. And as an after thought I checked the blade for square again. It was almost perfect again. Any ideas on what would cause it to be heeling in and out slightly?
    And I guess if it continues to make square cuts, it really isn't a problem.

    Comment

    Working...
    X