Announcement Announcement Module
Collapse
No announcement yet.
Jacking up a R4512 table Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Jacking up a R4512 table

    I was hoping I could jack up the table+motor so I can remove the base to install the dust collection chute (which I did not install when I originally assembled the saw) without taking the rails and extension tables off. Has anyone done this? I have a bunch of concrete blocks, a 4x4, and some bottle jacks, but I can't find a great way to situate the jacks because the overhang of the cast iron table is so small. Has anyone done this? Care to share your methods?

    Thanks,

    David
Working...
X