If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
That's "snipe". Are you using the cutterhead lock? If not...try it. If so, and you're still getting snipe, there's something not aligned correctly....may just the table, but see your manual for instructions.
One technique you may try (if you are not already) is this: feed the work piece into the planer at a slight downward angle and receive the work piece at a slight upward angle. This will help reduce snipe.