No announcement yet.

where is the vernier

  • Filter
  • Time
  • Show
Clear All
new posts

  • where is the vernier

    i can't find this vernier on my 1250 lazer miter saw i have looked all over the front the clear sight window has no lines on it, its even hard to see the 1/2 degree lines other than this its an excellent saw i love already after 2 weeks building my work shop i was going to buy a table saw but with this and my circular saw i may not even need the table saw for a while, my manual does not show the vernier but the online does has this been changed on the new models? i can't figure hop to do partial degrees