Announcement Announcement Module
Collapse
No announcement yet.
Tolerances on Rigid jointer Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Tolerances on Rigid jointer

    What are the normal/acceptable tolerances on a jointer? The beds are less than .005; however, the extension table on which the fence rides on a keyway are about .011 - .006 above the outfeed table. 'Tis my first jointer and am looking forward to running a bunch of board feet tomorrow.

    Thanks in advance,
    Jack
Working...
X